Pages Menu
TwitterRssFacebook
Categories Menu

Posted by on Jun 3, 2015 in Maintenance advices, My Blog, Pool Filters |

9 Successful Steps for Cleaning a Pool

It is pool time. It’s the moment when you are weighing up your option on the best way to clean and maintain your swimming pool. For many, this means employing a professional service technician to perform the task once or twice a week. However, you can take care of your pool service riverside ca yourself using these nine simple tips.

Riverside Pool Service Tools1. Assemble Your Tools

Inspect the inventory of your pool cleaning supplies and ensure you have everything you need. Check the expiration dates on all pool chemical containers before you begin, and ensure you have all the basic accessories needed to clean the swimming pool in place.

2. Remove the Cover

During the winter and fall, your pool cover accumulated debris and water. Make sure you remove all the debris carefully from the pool cover before you start the cleaning process. Pool service riverside ca recommend that you use a submersible pump to siphon off the gathered rainwater. Once the water and debris are removed from the cover, clean the pool cover with a mild detergent mixed with water using a scrub brush, and lay it out flat to dry.

pool service Riverside CA filter3. Check Your Equipment and Filters

Remove any water in the tubes; unplug the piping both at the filter system area and in the pool. If possible, replace filter media when they are used for over two years. Make sure any plug and gasket is in good condition. Generally, inspect all the equipment thoroughly for proper installation and operation by consulting reputable riverside pool service company.

4. Brash the Sides and Ledges

Every week, brush the sides and bottom of the pool before you run the pump. The debris that was clinging to the sides will be suspended in the water and will exist through or caught by your filter medium.

5. Filter and Circulate

Regardless of the size of the solids, they must be filtered out of the pool water. Remove the particles faster before they have the chance to become part of sludge on the bottom of the pool. If you allow these solids to be in the pool water, they will contribute to the growth of algae and bacteria, which eventually changes the water chemistry in the pool. The basic principle is to pump the water under pressure through the filter medium to capture and remove all the solids before running the filtered water into the pool. Depending on the speed of the pump and the size of the pool, you should run the filtration cycle for at least two hours.

6. Clean the Bottom

Perform a weekly cleaning in the summer, or as required in the winter, using a bottom cleaning system such as an electric underwater robot, pop-ups, a vacuum on a pole or a pump-driven vacuum. Take your pick, but ensure it is working so that your pool is cord and horse-free.

7. Backwash Your Filter

A solid filter should be back-washed monthly. Cartridge filter must be removed or replaced regularly. For other filter, read the manual instruction, but never use it more than three years.

8. Test the Water

Now that your pool water is relatively clear, check the chlorine and PH levels with a testing kit and adjust to proper levels. Ideally, the chlorine levels should be between 2.1 and 4.0 parts per million, while the PH levels should be between 7.1 and 7.9. Remember, do not mix various swimming pool chemicals and always read the instructions given by the manufacturer.

9. Shock the Pool

Chlorine shock products are available in granular and solid form. You need to add the right amount to raise the chlorine level of the pool to about 3.0 parts per million. Don’t just throw chlorine directly into the pool as this might cause staining or bleaching of the liner. Allow the pool to run for 24 hours after chlorination and then retest the chemical properties of the water in the pool.

Enjoy your pool!

Read More